How To Light Pilot On Gas Fireplace With Remote

Published by adminsaja on

How To Light Pilot On Gas Fireplace With Remote. Here’s how to light a gas fireplace with a control panel. Reset the knob to the pilot position:

Pilotlight switch for a gas fireplace? The Washington Post from www.washingtonpost.com

Once the pilot is lit, continue to hold the valve knob in for 60 seconds, then slowly release. Continue pressing down on the knob, and press on the ignition switch at least once every second. Simply pressing the wall switch or correct button on a remote control can light a gas fireplace with electronic ignition in an instant.

Push In The Pilot Knob, Which Manually Sends Gas Into The System.

Always remove your fireplace glass prior to lighting your pilot. While pressing down the control knob in the pilot position, press the ignition switch. Continue pressing down on the knob, and press on the ignition switch at least once every second.

And When You Slide The Switch At The Off Position, The Device Will Remain Off.

“on”, “off”, and “remote”, in front of the receiver. This will ensure that the pilot light stays burning indefinitely, allowing you to use the device’s wall switch or remote control to turn on the fireplace whenever you like. Once the pilot is lit, continue to hold the valve knob in for 60 seconds, then slowly release.

How To Light Pilot On Gas Fireplace With Remote.

Simply pressing the wall switch or correct button on a remote control can light a gas fireplace with electronic ignition in an instant. Push in knob (this releases the gas to the pilot area only). Refer to your user manual for a.

See also  How To Turn Off Javascript On Iphone

If There’s A Battery Backup, The Pilot Light Could Be On Without Any Gas Going To The Fireplace.

Gas fireplaces with electronic ignition will typically have a way to light it in the form of a wall switch and/or a remote control. Remember to do this when you are ready to ignite the pilot light of your gas fireplace. If your pilot light does not ignite, wait a few seconds and try again.

While Holding Down The Pilot Button, Light A Match Close To The Fire’s Piping.

Newer generations of gas fireplaces and appliances use an electronic ignition system. If you keep the fireplace switch in the on position, the receiver will stay on until you slide it to the remote or off position. How to light the pilot on a monessen gas fireplace.


0 Comments

Leave a Reply

Avatar placeholder

Your email address will not be published.