How To Program A Ford Transponder Key Without Original. Turn the device off and on again; Leave it in the “on” position for 10 and a half minute.
If you need to start your vehicle engine system, you have to get the right transponder key programming, to perform this transponder key bypass process. In this guide, we look closer at what the transponder key is and how it works. Without the chip in the key, the car will not start.
Firstly, Insert The New (Unprogrammed) Cut Transponder Key In The Ignition.
Step 2 is to put this ford key in the ignition switch of your ford vehicle and turn it on. Put the key inside the ignition, and turn on the car. When the light goes off, you must repeat the process a total of three times until the key is programmed.
You Can Reprogram A Fresh Key From The Driver’s Seat, In A Few Minutes, But You Will Need Two Programmed Keys Plus An Extra Key That Is Yet To Be Programmed.
Leave it on for about 15 minutes until you notice that the security light is gone. Most people don’t know that they can program a ford key without the original. Without the chip in the key, the car will not start.
Once You Get The Security Alert, You Need To Wait 15 Minutes Before Proceeding.
Turn on the electric lock; And you don’t need your vin number for it either. To program the transponder key, you want to put it in the ignition and set it to the on position.
In A Similar Way As Step 2, Rerun The Procedure And Put The Transponder Key In The “Off” Position Again In 45 Seconds.
Enter your vehicle with two of your programmed keys and the new key you are yet to program. When the light goes off, you must repeat the process a total of three times until the key is programmed. Turn the device off and on again;
As This Is Done, Get Back To The “On” Position.
The programming process isn’t complicated, but your type of car also determines that. Turn the key to the “on” position. But any key without the appropriate programming can open your car doors.